Detcon PI-600 Manuel d'utilisateur télécharger pdf (Page 29)

and push down on the end with the pins. Make sure the cell assembly is flush with the lamp window.

4) Place the spacer around the assembly.

5) Place the filter media over the Cell Assembly centered on the top of the sensor. Make sure the filters are installed in

the correct order. Filter Media #2 first, then Filter Media #1 on top, with the shiny side up.

6) Align the Cap Key with the notch on the housing. Starting at the side opposite the notch, press down until the

Filter Cap snaps on to the housing. If the Cap Key is incorrectly aligned there will be a noticable buldge on the side of

the Cap.

PI-600 Toxic Gas Sensors PG.29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Detcon PI-600 Manuel d'utilisateur Page 29